Connecting the Desk Phone

Modified on Thu, 29 Feb at 7:30 AM

In this Guide you will see the back of the Grandstream GRP261x and GRP262x Desk Phones and how to properly connect them.

LAN Port - this is where you connect RJ-45 CAT5e/6 Network Cable.

Handset Port - This is where you connect the coil cord and the Handset.

Headset Port - This is where you connect the RJ-9 Headset. Do not plug the Handset into this slot as you will have dead air.

Power - This is where you plug in the Power Adapter. Do not use this unless instructed by NVG Communications Support.

PC Port - This where you can connect your PC or Laptop. Do not use this unless instructed by NVG Communications Support.

USB Port - On selected Models. Used for USB Headsets or GBX20 Extension Module.

Kensington Lock - Do not use.

GRP2612W

GRP2613

GRP2624

GRP2614

GRP2615

GRP2616

PHONE STAND

You may adjust the positioning of the Phone Stand according to your preference.

CONNECTING THE PHONE

Connect the 5V DC output plug to the power jack on the phone; plug the power adapter into an electrical outlet. If a PoE switch is used in step 3 (GRP2612P/GRP2612W/GRP2612G only), this step could be skipped.

Using Ethernet - all Models:
- Connect the LAN port of the phone to the RJ-45 socket of a hub/switch or a router (LAN side of the router) using the Ethernet cable.

Using Wi-Fi (GRP2612W, GRP2614, GRP2615, GRP2616, GRP2624, GRP2634, GRP2636, GRP2650, GRP2670):
- Press the MENU button (circle button between the arrow buttons).
- On LCD menu, navigate to “System → Wi-Fi settings” and enable Wi-Fi if it displays "Disabled" by using left or right arrow buttons.
- Select “Scan” and GRP261x or GRP262x Phones will automatically start scanning within the range of Wi-Fi signal.
- A list of Wi-Fi networks will be displayed. Select the desired network, then enter the correct password to connect. Keep in mind, a Wi-Fi password might include Capital/Lower letters, numbers or even special characters.